Email: info@tyuelec.com Tel: +86-577-62511131
English
Flux-Cored Wire EC410NiMo Featured Image
  • Flux-Cored Wire EC410NiMo

Flux-Cored Wire EC410NiMo

Short Description:

EC410NiMo is a martensitic stainless steel flux-cored wire with chemical composition containing 11.0 – 12.5% Cr, 4.0 – 5.0% Ni, and 0.40 – 0.70% Mo.

Product Detail

Product Tags

Corresponding Standard

GB/T 17853-2018 TS410NiMo-FC11

AWS A5.22M-2012 E410NiMoT1-1

Equivalent Mterial: 13Cr-4Ni (EN1.4313/UNS S41500)

Description

EC410NiMo is a martensitic stainless steel flux-cored wire with chemical composition containing 11.0 – 12.5% Cr, 4.0 – 5.0% Ni, and 0.40 – 0.70% Mo. It is suitable for all-position flux-cored arc welding (FCAW) with stable arc, minimal spatter, and excellent slag detachability. The deposited metal has good wear resistance, crack resistance, and mechanical properties.Preheating at 150 – 260℃ is recommended, and post-weld heat treatment (PWHT) at 590~620℃ for 1 hour (followed by air cooling, AC) is required after welding.

Application

Ideal for welding ASTM CA6NM cast steel and 13%Cr – 4%Ni series steels. Used for hardfacing repair of crane rails, printing rollers, steel shafts, cavitation-worn hydropower components, and structural parts requiring corrosion and wear resistance.

Chemical Composition of Weld Metal (%)

Element C Cr Ni Mo Mn Si P S Cu
Requirement ≤0.06 11.0-12.5 4.0-5.0 0.40-0.70 ≤1.00 ≤1.00 ≤0.040 ≤0.030 ≤0.75
Test Result 0.02 12.3 4.65 0.54 0.59 0.33 0.023 0.01 0.01

Mechanical Properties of Deposited Metal

Test Name Tensile Strength(MPa) Elongation%  X-Ray Impact Test(+20℃)J Hardness HB Diffusible Hydrogen(ml/100g)
Requirement ≥760 ≥15  Grade I – – ≤5
Test Result 845 19  Grade I 60-90 250-310 ≤5

 

Recommended Welding Parameter

Power Source: DC Reverse (DC-)

Wire Diameter & Current:

Recommended Current:

Rod Diameter(mm) 3.2 4.0 5.0
Welding Current(A) 80-120 120-160 150-190

Notice

1.Bake the electrode at 300℃ for hour before use to remove moisture .

2.Clean rust, oil, and moisture from the base metal surface; use short arc operation for narrow weld beads .

3.PWHT should be performed immediately after welding to avoid embrittlement .

 

 

  • Previous:
  • Next:

    • Related Products